High Nails in Shingles: What an Installation Review Looks For
High nailing means the fastener is positioned too far up the shingle relative to the required nailing area. It is a placement issue, which is different from a nail head sticking up. A reliable review compares the actual shingle variant and observed fastener locations with that product’s installation instructions.
Start with the correct drawing
GAF’s high-nailing bulletin directs installers to the relevant product instructions and notes that some premium shingles have different nailing areas. A dimension copied from another shingle is therefore an unreliable basis for accepting or rejecting your installation.
Ask for the manufacturer, full product name and applicable installation document. If the roof was installed in the past, have the reviewer establish which version applies rather than assuming a current brochure describes the supplied product exactly.
A branded line printed on a shingle may help the installer, but the review should explain what the applicable diagram requires. Avoid arguing about a photograph until the reviewer and installer are comparing the same product and reference.
Separate location from depth
Three different descriptions can appear in the same inspection report:
| Term | Question being answered |
|---|---|
| High nailing | Is the fastener too far up the shingle? |
| Underdriving | Is its head above the intended seating position? |
| Overdriving | Has it been driven into or through the shingle surface? |
A fastener may have more than one problem. Keeping the terms separate makes the proposed correction easier to evaluate. A photo of a raised head does not, by itself, show that the nail is outside the nailing zone.
Ask what the sample actually establishes
Fasteners are commonly concealed by overlapping courses. Owners should not lift shingles to gather their own evidence. Request a qualified review with a documented access method and an explanation of how inspected areas will be restored.
Ask how many locations were examined, where they were and whether the selection was representative or targeted to an existing problem. Neither a single correct location nor a single incorrect one describes the entire roof. If the reviewer extrapolates, the report should explain the basis and limitations.
Save original installation photographs if available. A clear image captured before the next course covered the fasteners may be useful; a wide completion image normally answers a different question.
Evaluate the proposed correction
The remedy should address the specific product and the affected area, including the shingle seal disturbed by inspection or repair. Ask whether the shingles can be retained, whether other damage changes the scope and which installation detail supports the proposed work. Do not accept an unexplained “add more nails” instruction as a complete plan.
Separate the physical findings from responsibility and coverage. Manufacturer warranty, installer workmanship obligations and an insurance policy are different documents; the word “high-nailed” does not settle any of them automatically.
For product identification, consult the roofing materials catalog. If an inspection raises fastening concerns, request a written repair scope tied to the actual findings and supporting product instructions.